Chapter 15 Fiber Testing
3
4
5
6
7
Figure 77
Performing fiber inspection
Capturing fiber image
Procedure
1
120
To select the pre-configured tip (optical settings) that you want to use, complete the following
steps:
a
Tap the drop-down list button for the Tip.
b
Select one of the tips available to your selected profile, from the following choices:
–
Standard Tips (with BAP1) and Simplex Long Reach (-L) Tips
–
Ribbon Tips and Ribbon Tips – Long Reach
NOTE
This setting allows you to select the best optical settings for the type of inspection tip
that is attached to your microscope probe.
To set the function of the QuickCapture button on the side of the P5000i, select the Test Button
option from the following choices:
–
Freeze and Test: Sets the capture button to function the same as the Test screen key on
your JD720C series. Pressing the QuickCapture button captures and analyzes fiber image.
–
Freeze Image: Sets the capture button to function the same as the Freeze screen key on
your JD720C seris. Pressing the QuickCapture button captures fiber image.
Optional. Select the Auto Center option between On and Off. Default setting is On.
It automatically displays the center of the fiber when viewing at high magnification.
Optional. To integrate stored OPM readings into a fiber analysis report, check the box for the
Link OPM readings with fiber analysis.
Tap the Apply button to save and exit.
Info/Setting window
Connect the fiber to be inspected to the tip of your microscope P5000i.
See the user manual of your fiber microscope for details on using the P5000i.
CellAdvisor JD720C User's Manual