Table of Contents
Advertisement
Chapter 12 High Power CW Signal Generating
1
2
3
4
102
To set the frequency of the signal, complete the following steps:
a
Tap the Frequency screen key.
b
Enter a value within the frequency range of your instrument by using the numeric keys,
and then press the ENTER hard key. You can also use the rotary knob.
To set the output level of the signal, complete following steps:
a
Tap the Power Level screen key.
b
Enter a value between -30 dBm and 10 dBm by using the numeric keys, and then press the
ENTER hard key. You can also use the rotary knob.
To start generating the set signal, toggle the RF Source screen key, and then select On.
To stop generating the signal, toggle the RF Source screen key, and then select Off.
CellAdvisor JD720C User's Manual
Advertisement
Table of Contents
