Next-Hop Ipv6; No-Fragment Enable - HPE FlexNetwork 10500 Series Network Management And Monitoring Command Reference

[Sysname-nqa-admin-test-icmp-echo] next-hop ip 10.1.1.1

next-hop ipv6

Use next-hop ipv6 to specify the next hop IPv6 address for probe packets.
Use undo next-hop ipv6 to restore the default.
Syntax
next-hop ipv6 ipv6-address
undo next-hop ipv6
Default
No next hop IPv6 address is specified for probe packets.
Views
ICMP echo operation view
ICMP/TCP half open template view
Predefined user roles
network-admin
mdc-admin
Parameters
ipv6-address: Specifies the IPv6 address of the next hop. IPv6 link-local addresses are not
supported.
Usage guidelines
If the next hop IPv6 address is not configured, the device searches the routing table to determine the
next hop IPv6 address for the probe packets.
Examples
# Specify 10::1 as the next hop IPv6 address for the ICMP echo operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] next-hop ipv6 10::1

no-fragment enable

Use no-fragment enable to enable the no-fragmentation feature.
Use undo no-fragment enable to disable the no-fragmentation feature.
Syntax
no-fragment enable
undo no-fragment enable
Default
The no-fragmentation feature is disabled.
Views
UDP tracert operation view
50