Ipv6 Netstream Export Rate; Ipv6 Netstream Export Source - HPE FlexNetwork 10500 Series Network Management And Monitoring Command Reference

Examples
# In system view, specify 40::1 as the IP address of the destination host and UDP port 5000 as the
export destination port number.
<Sysname> system-view
[Sysname] ipv6 netstream export host 40::1 5000
Related commands
ipv6 netstream aggregation

ipv6 netstream export source

ipv6 netstream export rate

Use ipv6 netstream export rate to limit the IPv6 NetStream data export rate.
Use undo ipv6 netstream export rate to restore the default.
Syntax
ipv6 netstream export rate rate
undo ipv6 netstream export rate
Default
The export rate of IPv6 NetStream data is not limited.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
rate: Specifies the export rate in the range of 1 to 1000.
Usage guidelines
This command sets the maximum number of IPv6 NetStream packets that can be exported per
second. Packets that cannot be exported due to the export rate limit are buffered for later export.
When the buffer is full, the system will temporarily invalidate the rate limit and export packets as fast
as possible until the buffer has space for new packets.
Examples
# Allow a maximum of 10 packets to be exported per second.
<Sysname> system-view
[Sysname] ipv6 netstream export rate 10
ipv6 netstream export source
Use ipv6 netstream export source to specify the source interface for data packets sent to
NetStream servers. The IPv6 address of the interface is used as the source IPv6 address of the data
packets.
Use undo ipv6 netstream export source to restore the default.
Syntax
ipv6 netstream export source interface interface-type interface-number
332