Ipv6 Netstream Aggregation - HPE FlexNetwork 10500 Series Network Management And Monitoring Command Reference

Predefined user roles
network-admin
mdc-admin
Parameters
inbound: Enables IPv6 NetStream for incoming traffic.
outbound: Enables IPv6 NetStream for outgoing traffic.
Examples
# Enable NetStream for incoming traffic on GigabitEthernet1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] ipv6 netstream inbound

ipv6 netstream aggregation

Use ipv6 netstream aggregation to specify an IPv6 NetStream aggregation mode and enter its
view.
Use undo ipv6 netstream aggregation to remove the configuration for an IPv6 NetStream
aggregation mode.
Syntax
ipv6 netstream aggregation{ destination-prefix | prefix | protocol-port | source-prefix }
undo ipv6 netstream aggregation{ destination-prefix | prefix | protocol-port | source-prefix }
Default
No IPv6 NetStream aggregation mode is specified.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
destination-prefix: Specifies the destination-prefix aggregation by destination AS number,
destination address mask length, destination prefix, and output interface index.
prefix: Specifies the source and destination prefix aggregation by the following criteria:
•
Source AS number.
•
Destination AS number.
•
Source address mask length.
•
Destination address mask length.
•
Source prefix.
•
Destination prefix.
•
Input interface index.
•
Output interface index.
protocol-port: Specifies the protocol-port aggregation by protocol number, source port, and
destination port.
329