HPE FlexNetwork 10500 Series Network Management And Monitoring Command Reference page 309
Hide thumbs
Also See for FlexNetwork 10500 Series:
- Security command reference (881 pages) ,
- Security configuration manual (702 pages) ,
- Configuration manual (407 pages)
Table of Contents
Advertisement
Usage guidelines
You can execute this command multiple times for a traffic behavior to mirror traffic to different
interfaces.
The encapsulation parameters for the mirrored packets are available only when the mirrored packets
are sent out of Ethernet interfaces.
Examples
# Create traffic behavior 1 and configure the action of mirroring traffic to Ten-GigabitEthernet 1/0/1
for the traffic behavior.
<Sysname> system-view
[Sysname] traffic behavior 1
[Sysname-behavior-1] mirror-to interface ten-gigabitethernet 1/0/1
# Create traffic behavior 1, and configure the action of mirroring traffic to Ten-GigabitEthernet 1/0/1
for the traffic behavior. Specify the following parameters for the mirrored packets sent to
Ten-GigabitEthernet 1/0/1:
•
Specify 1.1.1.1 and 2.2.2.2 as the source address and destination address, respectively.
•
Specify 20, 100, and vrf1 as the DSCP value, VLAN, and the VPN instance name, respectively.
<Sysname> system-view
[Sysname] traffic behavior 1
[Sysname-behavior-1] mirror-to interface ten-gigabitethernet 1/0/1 destination-ip
1.1.1.1 source-ip 2.2.2.2 dscp 20 vlan 100 vrf-instance vrf1
300
Advertisement
Table of Contents
