Ntp Commands; Display Ntp-Service Ipv6 Sessions - HPE FlexNetwork 10500 Series Network Management And Monitoring Command Reference
Hide thumbs
Also See for FlexNetwork 10500 Series:
- Security command reference (881 pages) ,
- Security configuration manual (702 pages) ,
- Configuration manual (407 pages)
Table of Contents
Advertisement
NTP commands
NTP is supported on the following Layer 3 interfaces:
•
Layer 3 Ethernet interfaces.
•
Layer 3 Ethernet subinterfaces.
•
Layer 3 aggregate interfaces.
•
Layer 3 aggregate subinterfaces.
•
VLAN interfaces.
•
Tunnel interfaces.
display ntp-service ipv6 sessions
Use display ntp-service ipv6 sessions to display information about all IPv6 NTP associations.
Syntax
display ntp-service ipv6 sessions [ verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
verbose: Displays detailed information about all IPv6 NTP associations. If you do not specify this
keyword, the command displays only brief information about the IPv6 NTP associations.
Examples
# Display brief information about all IPv6 NTP associations.
<Sysname> display ntp-service ipv6 sessions
Notes: 1 source(master), 2 source(peer), 3 selected, 4 candidate, 5 configured.
Source:
Reference: 127.127.1.0
Reachabilities: 1
Last receive time: 6
Roundtrip delay: 0.0
Total sessions : 1
[125]3000::32
Clock stratum: 2
Poll interval: 64
Offset: -0.0
Dispersion: 0.0
95
Advertisement
Table of Contents
