Sflow Source - HPE FlexNetwork 10500 Series Network Management And Monitoring Command Reference

Examples
# Enable flow sampling to sample a packet out of 32768 packets on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] sflow sampling-rate 32768
Related commands
sflow sampling-mode

sflow source

Use sflow source to specify the source IP address of sent sFlow packets.
Use undo sflow source to restore the default.
Syntax
sflow source { ip ipv4-address | ipv6 ipv6-address } *
undo sflow source { ip | ipv6 } *
Default
The source IP address of sent sFlow packets is determined by routing.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
ip ipv4-address: Specifies the source IPv4 address of sent sFlow packets.
ipv6 ipv6-address: Specifies the source IPv6 address of sent sFlow packets.
Examples
# Specify the source IPv4 address of sent sFlow packets as 10.0.0.1.
<Sysname> system-view
[Sysname] sflow source ip 10.0.0.1
346