Inspection Report (Pa-32R-300) - Piper Cherokee Six Service Manual

*PIPER CHEROKEE SIX SERVICE MANUAL
TABLE 11-11. INSPECTION REPORT (PA-32R-300)
Inspection Time (hrs)
I I
I
I
Nature of Inspection
B. ENGINE GROUP (cont.)
5. Clean pressure oil strainer or change full flow (cartridge type)
oil filter element (Inspect strainer or element for foreign
particles) .........................................................
6. Inspect oil temperature sender unit for leaks and security
..............
7. Inspect oil lines and fitting for leaks. security, chafing.
dents and cracks (See Note 8) ......................................
8. Clean and check oil radiator cooling fins (See Note 18) ................
9. Remove and flush oil radiator
......................................
10. Fill engine with oil per information
in lubrication chart .................
I 1. Clean engine .....................................................
CAUTION:
Do not contaminate
the vacuum pump with cleaning fluid.
(Ref: The latest revision of Lycoming Service Letter No. 1221.)
12. Inspect condition of spark plugs (Clean and adjust gap as
required, adjust per the latest revision of Lvcoming Service
Instruction
No. 1042.) ..........................................
NOTE:
If fouling of spark plugs has been apparent.
rotate bottom
plugs to upper plugs.
13. Inspect spark plug cable leads and ceramics for corrosion
and deposits ....................................................
14. Check cylinder compression
(Ref. AC43.13-1A)
........................
15. Inspect cylinders for cracked or broken fins ...........................
16. Inspect rocker box covers for evidence of oii leaks. If found,
replace gasket: torque cover screws 50 inch-pounds
(See
N o te 12) .. . .....
. . . . . .... . . . .. . .. . . . . .. .. . . .. .. . . . . .. . ... . . ..
. .
NOTE: Lycoming requires a Valve Inspection
be made
after
every
O
O O O
0 0
n
50
0
0
0
0
100 500
1000
I
400 hours of operation.
(See Note II)
17. Inspect ignition harness and insulators
(high tension leakage
and continuity)
.........................
.
IS. Check magneto points for proper clearance (Maintain
clearance at 0.016) .....................................
.....
19. Inspect magento for oil leakae
..............................
20. Inspect breaker felts for proper lubrication
............................
21. Inspect distributor
block for cracks, burned areas or
corrosion and height of contact springs ...............................
22. Inspect magnetos to engine timing
......... ..
............... ..
23. Inspect ignition switch operation (See the latest revision of
Piper Service Letter No. 758) ........................................
24. Overhaul or replace magnetos (See Note 7)...........................
25. Remove air filter and tap gently to remove dirt particles
(Replace as required) ...............................................
i
i
0
0 0
0 0 0
0 0
0 0
0
O 0 0
0 0
0
0
0 0
0 0 0
0
0 0
0
0 0
0 0 0
0
0 0
0
0
0
0 0
0 0
0
0
0 0
0
0
0 0
INSPECTION
0
0
Revised: 12/15/80
1E6