Note
Pasting program blocks
Jobshop machining steps cannot be copied into a G code program.
Precondition
You have opened a program in the Editor.
Procedure
See also
Copying/pasting/deleting a program block (Page 159)
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
1.
Press the ">>" and "Open 2nd program" softkeys.
The "Select 2nd program" window opens.
2.
Select the required program that you wish to display in addition to the
program that is already open.
3.
Press the "OK" softkey.
The dual editor opens and displays both of the programs next to one
another.
Machining the workpiece
4.10 Editing a program
161