Programming technological functions (cycles)
6. Retraction with G0 to the safety clearance of the reference point.
7. Retraction to retraction plane with G0 to drilling position in the two axes of the plane
Parameters, G code program
Drill hole at programmed position
for G code)
Position with MCALL
Z0 (only for G
Reference point Z
Direction of rotation
(only for G
Drilling depth (abs) or drilling depth in relation to Z0 (inc)
Dwell time at final drilling depth in seconds
Dwell time at final drilling depth in revolutions
Spindle stop position
Do not lift off contour
The cutting edge is not fully retracted, but traverses back to the retraction plane.
Lift off contour
The cutting edge retracts from the edge of the hole and then retracts to the safety
clearance from the reference point and then positions at the retraction plane and
hole center point.
Retraction distance in the X direction (incremental) - (for lift-off only, standard)
(coordinates of the hole center point).
The part program or ShopMill program to be processed has been
created and you are in the editor.
Press the "Drilling" softkey.
Press the "Boring" softkey.
The "Boring" input window opens.
Parameters, ShopMill program
Cutting edge number
S / V
Spindle speed or constant
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0