Parameters, G code program (undercut, thread DIN)
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
The part program to be executed has been created and you are in the
Press the "Turning" softkey.
Press the "Undercut" softkey.
Press the "Thread undercut DIN" softkey.
The "Thread Undercut (DIN 76)" input window opens.
- OR -
Press the "Thread undercut" softkey.
The "Thread Undercut" input window opens.
∇ + ∇∇∇ (roughing and finishing)
Parallel to the contour
Normal (form A)
Short (form B)
Thread pitch (select from the preset DIN table or enter)
Reference point X ∅
Reference point Z
Programming technological functions (cycles)
8.4 Turning - only for G code programs