1.4 User interface
Overview (Page 69)
Work offsets (Page 100)
The most important data concerning the current tool, the feedrate (path feed or axis feed in
JOG) and the spindle are displayed in the T, F, and S windows.
Name of current tool
Location number of current tool
Cutting edge of the current tool
The tool is displayed with the associated tool type symbol corresponding to
the actual coordinate system in the selected cutting edge position.
If the tool is swiveled, then this is taken into account in the display of the
cutting edge position.
In DIN-ISO mode the H number is displayed instead of the cutting edge
H number (tool offset data record for DIN-ISO mode)
If there is a valid D number, this is also displayed.
Diameter of current tool
Radius of the actual tool
Z value of the actual tool
X value of the actual tool
Actual feed value
If several axes traverse, is displayed for:
"JOG" mode: Axis feed for the traversing axis
"MDA" and "AUTO" mode: Programmed axis feed
G0 is active
No feed is active
Display as a percentage
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0