Magazine - Siemens SINUMERIK 840D Operating Manual

Tool management

12.8 Magazine

12.8 Magazine
Tools are displayed with their magazine-related data in the magazine list. Here, you can take
specific actions relating to the magazines and the magazine locations.
Individual magazine locations can be location-coded or disabled for existing tools.
Tool parameters
Column heading
Location
BS
* If activated in magazine
selection
Type
Tool name
ST
D
G
Mag.loctype
Tool.loctype
Ü
P
486
Meaning
Magazine/location number
The magazine location numbers.

The magazine number is specified first, followed by the location
number in the magazine.
If there is only one magazine, only the location number is displayed.
Load position in the load magazine

The following additional icons can also be displayed for other magazine
types (e.g. for a chain):
Spindle location as an icon.

Locations for gripper 1 and gripper 2 (applies only when a spindle

with dual gripper is used) as icons.
Tool type
Depending on the tool type (represented by an icon), certain tool offset
data is enabled.
The tool is identified by the name and the replacement tool number. You
can enter the name as text or number.
Replacement tool number (for replacement tool strategy).
Cutting edge number.
Disabling of the magazine location.
Display of magazine location type.
Display of tool location type of tool.
Marking of a tool as oversized. The tool occupies two half locations left,
two half locations right, one half location top and one half location bottom
in a magazine.
Fixed location coding.
The tool is permanently assigned to this magazine location.
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Milling