Corrections After Measurement Of The Zero Point - Siemens SINUMERIK 840D Operating Manual

Setting up the machine
2.6 Measuring the workpiece zero
2.6.12

Corrections after measurement of the zero point

If you store the workpiece zero in a work offset, changes to the coordinate system or axis
positions might be necessary in the following cases.
● Correcting the work offset causes the workpiece coordinate system to rotate, after which
● Correcting the work offset necessitates positioning of the rotary axis in order to align the
Activation windows help you to adapt the coordinate system and the axis positions.
Procedure
Activating work offset
Aligning and retracting the tool
98
3. Open the list of measurement versions, select the desired
measurement version using the <Cursor down> and the <Input> keys.
- OR -
3. Using the <Select> key, in the drop down list box, select the desired
measurement version, e.g. "Align plane".
The "Align plane" window opens.
4. Enter the required parameter in order to make the measurement as
usual.
- OR -
Press the "Back" softkey.
The selected softkey is assigned the new measurement version, in
this case, "Align plane".
the tool can be aligned perpendicularly to the plane.
workpiece parallel with the coordinate system
You stored the workpiece zero in a work offset that was not active
during measurement.
1. When you press the "Set WO" softkey, the activation window opens
asking whether you want to "Activate work offset Gxxx now?".
2. Press the "OK" softkey to activate the corrected work offset.
Rotating the workpiece coordinate system makes it necessary to
realign the tool to the plane.
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Milling