Displaying The Work Offset "Overview - Siemens SINUMERIK 840D Operating Manual

Setting up the machine
2.7 Work offsets
Procedure
Note
Further details on work offsets
If you would like to see further details about the specified offsets or if you would like to
change values for the rotation, scaling or mirroring, press the "Details" softkey.
2.7.2

Displaying the work offset "overview"

The active offsets or system offsets are displayed for all set-up axes in the "Work Offset -
Overview" window.
In addition to the offset (course and fine), the rotation, scaling and mirroring defined using
this are also displayed.
This window is generally used only for monitoring.
Display of active work offsets
Work offsets
DRF
Basic reference
External WO frame
Total base WO
G500
Tool reference
Workpiece reference
Programmed WO
102
1. Select the "Parameter" operating area.
2. Press the "Work offset" softkey.
The "Work Offset - Active" window is opened.
Displays the handwheel axis offset.
Displays the additional work offsets programmed with $P_SETFRAME.
Access to the system offsets is protected via a keyswitch.
Displays the additional work offsets programmed with $P_EXTFRAME.
Displays all effective basis offsets.
Displays the work offsets activated with G54 - G599.
Under certain circumstances, you can change the data using "Set
WO", i.e. you can correct a zero point that has been set.
Displays the additional work offsets programmed with
$P_TOOLFRAME.
Displays the additional work offsets programmed with $P_WPFRAME.
Displays the additional work offsets programmed with $P_PFRAME.
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Milling