Tool Management; Lists For The Tool Management - Siemens SINUMERIK 840D Operating Manual

Tool management

12.1

Lists for the tool management

All tools and also all magazine locations that have been created or configured in the NC are
displayed in the lists in the Tool area.
All lists display the same tools in the same order. When switching between the lists, the
cursor remains on the same tool in the same screen segment.
The lists have different parameters and softkey assignments. Switching between lists is a
specific change from one topic to the next.
● Tool list
● Tool wear
● Magazine
● Tool data OEM
Sorting the lists
You can change the sorting within the lists:
● acc. to the magazine
● acc. to the name (tool identifier, alphabetic)
● according to the tool type
● according to the T number (tool identifier, numerical)
Filtering the lists
You can filter the lists according to the following criteria:
● only display the first cutting edge
● only tools that are ready to use
● only tools that have reached the pre-alarm limit
● only locked tools
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
All parameters and functions required to create and set up tools are displayed.
All parameters and functions that are required during operation, e.g. wear and monitoring
functions, are listed here.
You will find the magazine and magazine location-related parameters and functions for
the tools/ magazine locations here.
This list can be freely defined by the OEM.
12
461