Changing And Adapting A Simulation Graphic; Enlarging Or Reducing The Graphical Representation - Siemens SINUMERIK 840D Operating Manual

Simulating machining

5.8 Changing and adapting a simulation graphic

+
5.8 Changing and adapting a simulation graphic
5.8.1

Enlarging or reducing the graphical representation

Precondition
The simulation or the simultaneous recording is started.
Procedure
...
188
Press the <CTRL> and <S> keys simultaneously to enable and
disable the single block mode.
1. Press the <+> and <-> keys if you wish to enlarge or reduce the
graphic display.
The graphic display enlarged or reduced from the center.
- OR -
Press the "Details" and "Zoom +" softkeys if you wish to increase the
size of the segment.
- OR -
Press the "Details" and "Zoom -" softkeys if you wish to decrease the
size of the segment.
- OR -
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Milling