Siemens SINUMERIK 840D Operating Manual page 413

Hide thumbs Also See for SINUMERIK 840D:
Table of Contents

Advertisement

Parameter
Description
X
Rotation around X
Y
Rotation around Y
Z
Rotation around Z
Projection
Position of the projection in space - (only for swivel mode, projection angle)
position
Xα, Yα, Zβ or Yα, Zα, Zβ or Zα, Xα, Zβ
Projection angle
Projection angle
Angle of rotation in the plane
Name of rotary
Angle of rotation of rotary axis
axis 1
1
Name of rotary
Angle of rotation of rotary axis
axis 2
2
Z
Angle of rotation in the plane
X1
Zero point of rotated surface X
Y1
Zero point of rotated surface Y
Z1
Zero point of rotated surface Z
Direction
Preferred direction, rotary axis 1 - (not for swivel mode direct)
+
-
Tool
Tool tip when swiveling
Correct
The position of the tool tip is maintained during swiveling.
No correction
The position of the tool tip is not maintained during swiveling.
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Programming technological functions (cycles)
- (only for axis sequence)
- (only for projection position)
- (only for direct swivel mode)
8.6 Further cycles and functions
Unit
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
413

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik828d

Table of Contents