Siemens SINUMERIK 840D Operating Manual page 326

Hide thumbs Also See for SINUMERIK 840D:
Table of Contents

Advertisement

Programming technological functions (cycles)
8.2 Milling
Note
Entering the engraving text
Only single-line entries without line break are permissible!
Variable texts
There are various ways of defining variable text:
● Date and time
● Quantity
● Numbers
● Text
Full circle
If you want to distribute the characters evenly around a full circle, enter the arc angle
α2=360°. The cycle then distributes the characters evenly around the full circle.
Parameters, G code program
PL
Machining plane
RP
Retraction plane
SC
Safety clearance
F
Feedrate
326
For example, you can engrave the time and date of manufacture on a workpiece. The
values for date and time are read from the NCK.
Using the workpiece variables you can assign a consecutive number to the workpieces.
You can define the format (number of digits, leading zeroes).
The place holder (#) is used to format the number of digits at which the workpiece counts
output will begin.
If you do not want to output a count of 1 for the first workpiece, you can specify an
additive value (e.g., <#,$AC_ACTUAL_PARTS + 100>). The workpiece count output is
then incremented by this value (e. g. 101, 102, 103,...).
When outputting number (e. g. measurement results), you can select the output format
(digits either side of the point) of the number to be engraved.
Instead of entering a fixed text in the engraving text field, you can specify the text to be
engraved via a text variable (e. g., _VAR_TEXT="ABC123").
mm
mm
mm/min
Parameters, ShopMill program
T
Tool name
D
Cutting edge number
F
Feedrate
S / V
Spindle speed or constant
cutting rate
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
mm/min
mm/rev
rpm
m/min
Milling

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik828d

Table of Contents