● Measuring cycle messages for tools
● Measuring cycle messages for workpieces
● Sinumerik messages/alarms (error when executing)
● Machine faults
● Maintenance intervals
● Additional alarm numbers:
● The user profile window is opened.
● You selected the event "Measuring cycle messages for tools", "Measuring cycle
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
An SMS is sent if measuring cycle messages are output that involve tools.
An SMS is sent if measuring cycle messages are output that involve workpieces.
An SMS is sent if NCK alarms or messages are output that cause the machine to come to
An SMS is sent if PLC alarms or messages are output that cause the machine to come to
a standstill (i.e. PLC alarms with Emergency Off response).
An SMS is sent if the service planner registers pending maintenance work.
Here, specify additional alarms where you should be notified if they occur.
You can enter individual alarms, several alarms or alarm number ranges.
messages for workpieces", "Sinumerik messages/alarms (errors when executing)",
"Machine faults" or "Maintenance intervals".
Activate the required check box and press the "Details" softkey.
The appropriate window opens (e.g. "Measuring cycle messages for
workpieces") and shows a list of the defined alarm numbers.
Select the corresponding entry and press the "Delete" softkey to
remove the alarm number from the list.
- OR -
Then press the "New" softkey if you wish to create a new entry.
The "Create new entry" window opens.
Enter the data and press the "OK" softkey to add the entry to the list.
Easy Message (828D only)
16.4 Setting-up events