Siemens SINUMERIK 840D Operating Manual page 81

Hide thumbs Also See for SINUMERIK 840D:

Table of Contents

Precondition

You can insert any tool in the spindle for scratching when measuring the workpiece zero

An electronic workpiece probe is inserted in the spindle and activated when measuring the

workpiece zero automatically.

Operating Manual, 03/2010, 6FC5398-7CP20-1BA0

Select the "Machine" operating area and press the <JOG> key.

Press the "Workpiece zero" softkey.

Press the "Right-angled corner" softkey if the workpiece has a right-

angled corner.

Press the "Any corner" softkey, if you want to measure a corner not

equal to 90°.

If these softkeys are not listed, press any vertical softkey (with the

exception of "Set edge") and in the drop-down list, select the desired

measurement version.

Select "Measuring only" if you only want to display the measured

In the selection box, select the desired work offset in which you want

to store the zero point.

Setting up the machine

2.6 Measuring the workpiece zero

Sinumerik828d