Mounting And Commissioning 3 - Siemens siprotec 7SD5 User Manual

Preface
Purpose of this This manual describes the functions, operation, installation, and commissioning of the
Manual device 7SD5. In particular, one will find:
• Descriptions of device functions and settings → Chapter 2;
• Instructions for mounting and commissioning → Chapter 3;
• List of technical data → Chapter 4;
• As well as a compilation of the most significant data for experienced users → Ap-
General information about design, configuration, and operation of SIPROTEC
devices are laid down in the SIPROTEC
Target Audience Protection engineers, commissioning engineers, personnel concerned with adjust-
ment, checking, and service of selective protective equipment, automatic and control
facilities, and personnel of electrical facilities and power plants.
Applicability of this This manual is valid for: SIPROTEC
Manual Protection 7SD5; firmware version V 4.3.
Indication of
Conformity
Further Standards
This product is UL-certified according to the Technical Data:
Additional Support Should further information on the System SIPROTEC
ular problems arise which are not covered sufficiently for the purchaser's purpose, the
matter should be referred to the local Siemens representative.
7SD5 Manual
C53000-G1176-C169-1
pendix A.
This product complies with the directive of the Council of the European Communi-
ties on the approximation of the laws of the Member States relating to electromag-
netic compatibility (EMC Council Directive 89/336/EEC) and concerning electrical
equipment for use within specified voltage limits (Low-voltage directive 73/23
EEC).
This conformity is proved by tests conducted by Siemens AG in accordance with
Article 10 of the Council Directive in agreement with the generic standards EN
50081 and EN 61000-6-2 for EMC directive, and with the standard EN 60255-6 for
the low-voltage directive.
The product conforms with the international standard of the series IEC 60255 and
the German standard VDE 0435.
IEEE Std C37.90-*
®
System Description /1/.
®
4 Line Differential Protection with Distance
®
4 be desired or should partic-
®
4
5