Siemens siprotec 7SD5 User Manual page 460

3 Mounting and Commissioning
Board C-I/O-2 The layout of the PCB for the C-I/O-2 board is shown in Figure 3-7.
Figure 3-7
The contact of the relay for the binary output BO13 can be configured as NO or NC
contact (see also General Diagrams in Appendix A, Section A.2):
with housing size
with housing size
Table 3-8
460
Input/output board C–I/O-2 with representation of jumper settings required for
checking configuration settings
1
/ : No. 3 in Figure 3-3, slot 33,
2
1
/ : No. 3 in Figure 3-4, slot 33 right.
1
Jumper setting for contact type of binary output BO13
Jumper Open in Quiescent State
(NO)
X41 1-2
Closed in Quiescent State
(NC)
2-3
Factory Setting
1-2
7SD5 Manual
C53000-G1176-C169-1