Siemens siprotec 7SD5 User Manual page 44

2 Functions
Addr. Parameter
133 Auto Reclose
134 AR control mode
135 Synchro-Check
136 FREQUENCY Prot.
137 U/O VOLTAGE
138 Fault Locator
139 BREAKER FAILURE
140 Trip Cir. Sup.
142 Therm.Overload
143 TRANSFORMER
144 V-TRANSFORMER
145 P. INTERFACE 1
146 P. INTERFACE 2
147 NUMBER OF RELAY
148 GPS-SYNC.
149 charge I comp.
160 L-sections FL
44
Setting Options
1 AR-cycle
2 AR-cycles
3 AR-cycles
4 AR-cycles
5 AR-cycles
6 AR-cycles
7 AR-cycles
8 AR-cycles
ADT
Disabled
Pickup w/ Tact
Pickup w/o Tact
Trip w/ Tact
Trip w/o Tact
Disabled
Enabled
Disabled
Enabled
Disabled
Enabled
Enabl. w. comp.
Disabled
Enabled
with BCD-output
Disabled
Enabled
Disabled
1 trip circuit
2 trip circuits
3 trip circuits
Disabled
Enabled
NO
YES
Not connected
connected
Enabled
Disabled
Disabled
Enabled
2 relays
3 relays
4 relays
5 relays
6 relays
Enabled
Disabled
Enabled
Disabled
1 Section
2 Sections
3 Sections
Default Setting
Disabled Auto-Reclose Function
Trip w/o Tact Auto-Reclose control mode
Disabled Synchronism and Voltage Check
Disabled Over / Underfrequency Protection
Disabled Under / Overvoltage Protection
Disabled Fault Locator
Disabled Breaker Failure Protection
Disabled Trip Circuit Supervision
Disabled Thermal Overload Protection
NO Transformer inside protection
zone
connected Voltage transformers
Enabled Protection Interface 1 (Port D)
Disabled Protection Interface 2 (Port E)
2 relays Number of relays
Disabled GPS synchronization
Disabled charging current compensation
1 Section Line sections for fault locator
Comments
7SD5 Manual
C53000-G1176-C169-1