Table of Contents
Advertisement
Chapter 6 Monitoring ECG
Connecting the ECG Cable To the X Series Unit
The X Series unit accepts Welch Allyn Propaq
X Series ECG cables. Connect the ECG cable to the ECG connector on the left side of the X
Series unit as follows:
Figure 6-3 Connecting ECG Cable to X Series Unit
Selecting ECG Waveforms for Display
You can fit up to four waveforms on the X Series display. The first waveform at the top of the
display is always an ECG waveform. (If
automatically default to another ECG lead.) In the following example, Lead
source of the ECG waveform trace:
6-6
06/06/2011
I, II,
III...
12
CO
2
R
SYNC
www.zoll.com
®
ECG cables as well as ZOLL
Pads
are not connected, the unit can be configured to
II
(RA-LL), is the
9650-001355-01 Rev. M
Advertisement
Table of Contents
