Table of Contents
Advertisement
Attaching the Invasive Pressure Transducer
Follow these steps when attaching the invasive pressure transducer:
1. Inspect the transducer cable. If the cable shows any signs of wear, breakage, or fraying,
replace the cable. Replace the transducer dome, if necessary.
Apply the transducer according to your organization's procedures. Always refer the
2.
manufacturer's Directions for Use before using a transducer.
If the transducer is a disposable unit with a separate cable, connect the transducer to the
3.
transducer cable.
Plug the transducer cable into one of the three six-pin IBP cable connectors on the side of the
4.
X Series unit.
Figure 11-1 Plugging the Transducer into the X Series
When you plug the transducer cable into the unit, the message ZERO PROBE appears in the
numeric display window for that IBP channel.
9650-001355-01 Rev. M
Attaching the Invasive Pressure Transducer
X Series Operator's Guide
11-3
Advertisement
Table of Contents
