Table of Contents
Advertisement
Chapter 6 Monitoring ECG
ECG System Messages
When monitoring ECG, the X Series unit may display the following messages:
System Message
LEAD FAULT
PADDLE FAULT or CABLE FAULT Check the pad, paddle or cable and replace if
Note:
6-10
If an ECG Monitoring cable is intentionally disconnected, you can disable the Lead
Fault alarm by Pausing (Suspending) the alarm audio. See "Pausing (Suspending)
Alarms" on page 5-6 for more information.
www.zoll.com
Cause
The current ECG source lead is defective (check
lead and replace, if necessary).
-- OR --
An unavailable waveform source has been specified
for the trace display (check specified waveform
source and correct, if necessary).
necessary.
9650-001355-01 Rev. M
Advertisement
Table of Contents
