Enabling/Disabling Spo2 Alarms And Setting Alarm Limits - ZOLL X Series Operator's Manual

Enabling/Disabling SpO
When enabled, the X Series unit sounds alarms whenever measurements are outside set limits
for the high and low SpO
SpHb, SpOC, PVI and PI values).
You can enable (or disable) alarms and set Upper and Lower alarm limits through the Alarms
quick access key (
To configure alarms through the Alarms quick access key:
1. Press the More quick access key (
Press
2.
Press the Limits quick access key (
3.
Use the navigation buttons to highlight and select the appropriate alarm menu selection
4.
(SpCO, SpMet, SpHb, SpOC, PVI, PI).
On the selected Alarm Settings menu, use the navigation keys to select the fields that you
5.
want to change. The fields are
Upper Limit Enable
•
Lower Limit Enable
•
Upper Limit
•
Lower Limit
•
When you are finished changing values on the alarm menu, navigate to the Backarrow key
6.
to exit the menu.
Note:
Setting Upper and Lower SpO
Initially, the SpO
disabled (
limits can be
adult, pediatric, and neonate patients, and gives the range in which you can set these limits.
Patient Type
Adult
Pediatric
Neonate
9650-001355-01 Rev. M
Alarms and Setting Alarm Limits
2
values (and, if installed and monitoring is on, SpCO and SpMet, and
2
)or through the SpO
.
If you set the SpO low alarm limit below the low limit default (85%), the X Series
2
issues an equipment alert.
Alarm Limits
2
Alarm Settings menu specifies whether the SpO
2
), and displays the default upper and lower SpO
OFF
or (default is
ON OFF
SpO Limit Default
2
Lower: 85%
Upper: 100%
Lower: 85%
Upper: 100%
Lower: 85%
Upper: 95%
X Series Operator's Guide

Enabling/Disabling SpO2 Alarms and Setting Alarm Limits

Parameter Control Panel.
2
).
).
Limits
).The following table lists the default SpO
OFF
SpO Limit Range
2
Lower: 50 - 98%
Upper: 52 - 100%
Lower: 50 - 98%
Upper: 52 - 100%
Lower: 50 - 98%
Upper: 52 - 100%
alarms are enabled (
2
limits. The upper and lower
2
limits for
2
) or
ON
10-11