Barco S3 User Manual page 479

Event master devices

Hide thumbs Also See for S3:

Table of Contents

Note: From this step, only the other end of the Genlock cable stays connected to the motherboard. Unfortunately it is necessary

to remove the motherboard from the motherboard mount to unplug it. (refer to the "Process Overview", page 418).

3. Remove the following parts to access the motherboard :

Rear cards (VPU, Link, I/O)

Link card interposer.

Note: Refer to the related procedures to remove these parts. Remove these parts requires removing lot of parts from the unit

(Power supply, Power interposer, Power supply guide, Side Support Plate ...)

Note: It is not necessary to remove the solid state memory, the system battery and the other cables to give access to the

motherboard ﬁxing screws.

4. Remove the Motherboard from the Motherboard mount.

R5905948 EVENT MASTER DEVICES 17/07/2017

14. S3 Maintenance

Troubleshooting