Barco S3 User Manual page 132

6. EM GUI orientation
Outputs can be added in reverse order, or even un even order allowing for correction of wrongly connected
wires
Image 6-25
How to delete Destination
1. Click on the Delete Destination(s) button
The Delete Destination(s) button is replaced by the Delete Selected button (highlighted in red) and the unit diagram is greyed
out, except the area dedicated to destinations (Screen and Aux).
2. Click on destination in the graphical area.
Or,
click in the "x" on the right hand side in the destination configuration list.
Image 6-26
Destination(s) is immediately outlined in red.
3. The deletion is completed by clicking the Delete Selected button.
Any output can be deleted from a destination at any time. For example, if the output that is automatically
assigned to a destination is not the desired one, then it can be deleted.
All destinations can be deleted the same time by clicking the "Select All" button.
How to access to the Destination configuration adjustments
Adjustments to Destinations are performed in the "Adjust" panel:
1. Select the destination from the configuration list
Or,
clicking on the graphic representation the destination in the Diagram area.
A Destination is selected.
2. Click on the Adjust tab that is on the top of the Adjustment area.
128 R5905948 EVENT MASTER DEVICES 17/07/2017