Configuration Menu > System Modifier Area - Barco S3 User Manual

6.10 Configuration Menu > System modifier area
General
General parameters concerning the selected system are accessible in this area. The user can select the system's preset conflict
mode, the native rate, and genlock mode.
Description
Image 6-13
• Preset Conflict: Mode—When using single layers conflicts can arise when a Preset Recall modifies a source layer that is
currently on Program. You may choose from three Preset Conflict Modes to resolve these conflicts.
- Auto—The system performs the necessary actions to gracefully recall the Preset to Program.
- Force Recall—The system recalls the Preset directly to Program. Program is not protected.
- User Confirm—The system presents the user with a pop-up asking what to do when a conflict is detected.
User Confirm options:
Resolve – All Trans or Cut: Perform the necessary actions to resolve the conflict and perform an All Trans or Cut to
o
bring the Preset to Program.
Resolve – Wait: Perform the necessary actions to resolve the conflict and wait for the user to press the All Trans or Cut
o
manually.
Cancel: Cancels the entire Preset recall operation.
o
- Off—The system alerts the user with an error message about any Preset recall conflict, but it does not present a pop-up
menu for resolving the issue.
• Preset Conflict: Time(frame) is the amount of time the system uses when automatically performing an All Trans.
• Native rate: System native rate in Hz (Cycles in second). Available selections:
The native system rate needs to match the general frame rate in the event where the unit is used.
• Genlock mode: Selects the system genlock mode to Freerun or Lock to External.
• Genlock Status: Reports the system's genlock mode status: Locked or not Locked.
• H Offset: The H sync can be offset to match a Genlock situation. Adjustment in mS.
• V Offset: The V sync can be offset to match a Genlock situation. Adjustment in mS.
• Master VP: Reports the units IP address in the local network.
• Unit ID: Reports the units ID number. ID required to identify different units are acting as a single or linked system in order to
expand for Inputs, Outputs or Layers.
R5905948 EVENT MASTER DEVICES 17/07/2017
23.98
24
25
29.97
30
47.95
48
50
6. EM GUI orientation
59.94
60
103