Barco S3 User Manual page 134

6. EM GUI orientation
Assign Menu
A word about layers
Adding to the general description above about layers, mores specifically a EMP´s Screen Destination has 1 fixed Mixing layer, its
BG. Then there are a number of mixing layers available in the system.
The E2 has 2 Banks of 8 Mixing Layers for a total of 16 Mixing Layers or 32 Single Layers (32L). These 16 Mixing Layers can be
assigned to Destinations, using up to 4 Outputs (1 Bank). If a Destination uses Outputs from both Banks, the Mixing Layer count is
reduced to 8. An E2 Jr. has a single Bank of 8 Mixing Layers for a total of 8 Mixing Layers or 16 Single Layers (16L).
An S3–4k has 1 bank of 4 Mixing Layers for a total of 4 Mixing Layers or 8 Single Layers (8L). These 8 Mixing Layers can be assigned
to Destinations, using up to 4 Outputs (1 Bank). An S3–4k Jr. has a single Bank of 2 Mixing Layers for a total of 2 Mixing Layers or
4 Single Layers (4L).
Processor
E2
E2 Jr.
S3–4K
S3–4K Jr.
EX
130
• Name: Adjusts the name of the Destination.
• Destination type: Reports the type of destination Screen
or Aux. Can convert from Screen to Aux if it meets
requirements.
• Number of output(s): Reports the number of output
configurations in the destination.
• Dimension: Adjust the output configuration layout .
• Auto configure Output format: Reads the EDID information
of the connected device to acquire its format. If more than
one device is connected to the destination, it reads the
format of the first output. This feature is not available for
SDI outputs.
• Output(s) format: Adjusts the output format of the
destination. This is applied to all outputs that are added into
this destination.
If you cannot find the output format in the list, it is possible
that the connector capacity for the connector is too small.
Remove the outputs from the Destination; update the con-
nector capacity; and check again. (Refer to "Configuration
Menu > Adjustment > Output Configuration", page 118, and
see the subsections "How to delete Output" and "Output ad-
justment panel > Connector Menu.")
• Outputs: Provides a list of the output configurations
assigned to the Destination.
For Aux destinations, only 1 Output configuration is shown
or is allowed to be defined. From this menu outputs can be
deleted or added as in the output configuration menu.
• Layer (only applicable when Destination is a Screen). You
can assign a size to the Layer: SL (2K Single Link), DL
(Dual Link), or 4K. You can also make the Layer either a
Mixing Layer or a Single Layer.
The list shows the Layers assigned to this Destination.
Banks
2
1
1
1
NA
Mixing Layers
16
8
4
2
NA
R5905948 EVENT MASTER DEVICES 17/07/2017
Single Layers
32
16
8
4
NA