Programming Menu > Adjustment Area > Source Adjustment - Barco S3 User Manual

6.28 Programming Menu > Adjustment area > Source adjustment
General
The Source adjustments are shown on the Adjust panel when a layer with a valid Source is selected. The Source adjustment controls
does not appear when you select the Source by itself. Also note that the adjustments made here are made on the layer's copy of
the Source, not the actual Source itself. The actual Source is updated only when the "Save Source" is pressed.
Description
When a layer with a valid Source is selected, 2 adjustment tabs are shown. It defaults to showing the layer adjustments. But the
user can click on the Source adjustment tab to see the adjustments mentioned in this section.
Two Tabs for Source adjustment:
• Main adjustment : Size, position, Aspect ratio, and Bind to User Key.
• Color adjustment: Contrast, Brightness, Gamma, Hue and Saturation
Main adjustment
R5905948 EVENT MASTER DEVICES 17/07/2017
The following Source Adjustment Menu functions are provided:
(All figures are in pixels)
• H Size: adjusts the source's horizontal size.
• V Size: adjusts the source's vertical size.
• H Position: adjusts the source's horizontal position.
• V Position adjusts the source's vertical position.
• Save Source would save the Source information from the
selected layer to the actual Source
Note that the "Custom aspect ratio" is disabled unless the
"Default Layer Aspect Ratio" is set to Custom.
6. EM GUI orientation
189