Updating Firmware - Barco S3 User Manual

Event master devices

Hide thumbs Also See for S3:

Table of Contents

8. UPDATING FIRMWARE

About this chapter

This chapter provides a detailed procedure for upgrading Event Master series processor software (ﬁrmware).

The Event Master series processor provides two options for upgrading ﬁrmware via the front panel menu:

Using the USB port on the front panel.

Using the Web Upgrade.

A third solution is available to upgrading the Event Master series processor with the built-in web interface.

For details on the upgrade procedure via the Setting Menu in the Event Master Toolset Software (EM GUI),

please refer to chapter "Settings Menu > Web App area > Tools > Manage Software", page 212

In the event the Event Master series processor gets into a state in which it constantly reboots after a software

upgrade, press and hold the SEL and ESC keys simultaneously until the front panel shows the choice of per-

forming a factory reset or continuing. Performing a factory reset will allow the Event Master series processor

to boot normally.

Upgrading ﬁrmware using the USB port

Upgrading ﬁrmware using the web Upgrade

R5905948 EVENT MASTER DEVICES 17/07/2017

8. Updating firmware

Troubleshooting