Record Of Changes - Barco S3 User Manual

1.2

Record of changes

Overview
Revision
00
01
02
03
R5905948 EVENT MASTER DEVICES 17/07/2017
Changes
Initial version
• Changes initiated by:
- New software version (V2.0).
- S3-4K and EC-50 product releases.
• In the entire of the document, the references to E2 have been replaced by reference to the Event
Master processors.
• A record of changes (this section) has been added.
• S3–4K product has been added. Chapters concerned by this new Event Master processor have
been modified:
- Description in General chapter + How to install S3 in a rack.
- Detailed explanations concerning new hardware in the Hardware Orientation chapter.
• EC–50 product has been added. Chapters concerned by this new controller have been modified
or added:
- Description in General chapter.
- New chapters dedicated to Controller Orientation, Controller Configuration and Controller
Operation.
• A new version off Event Master Toolset is available (V2.0). The GUI orientation chapter and the
System setup procedure have been updated.
• Two units can be linked. A section in the GUI orientation chapter describes how set up a linked
System.
• A new chapter concerning the maintenance of the S3–4K has been added.
• A new chapter concerning the maintenance of the EC–50 controller has been added.
• Annex:
- New section with S3 specifications.
- Remote command ATRN updated.
- New chapter "THIRD PARTY SOFTWARE ACKNOWLEDGEMENTS" added.
• Changes initiated by:
- New software version (V3.0).
- EC-200 product release.
• EC–200 product has been added. Chapters concerned by this new controller have been modified
or added:
- Description in General chapter.
- New chapters dedicated to Controller Orientation, Controller Configuration and Controller
Operation.
• The Front Panel Menu orientation chapter has been updated:
- a modification in the front menu panel of the "Event Master Processor" to take into account a
configuration created offline and transferred via USB device.
• A new version off Event Master Toolset is available (V3.0). The GUI orientation chapter has been
partially updated. A more complete update of this chapter will be performed at the next version
of the document.
- Win 10 has been added in the list of Operating Systems that accepts the "Event Master Toolset"
Software.
- A new section describes the Controller menu.
• A new chapter concerning the maintenance of the EC–200 controller has been added.
• Annex:
- New short section with EC-50 specifications.
• Changes initiated by:
- New software version (4.0).
- EX, E2 Jr., and S3–4K Jr. product releases.
• Updated RoHS table, taking into account the March 2016 changes.
1. Introduction
9