Barco S3 User Manual page 254

7. System Setup
2. Activate and Adjust Flip effect for the layer.
3. Activate Freeze effect for the layer. This also have a shortcut in the bottom of the workspace.
4. Activate and Adjust Color Effects for the layer.
5. Activate Monochrome effect for the layer.
6. Activate Invert effect for the layer.
If the Layers are supposed to toggle between Preview and Program, click the Toggle button in the top of the
Destinations Preview.
A source can be dropped into the Program of an Aux if the Program is Un-Locked. Un-lock the Program by
clicking on the small white lock in the bottom of the Destination.
(Optional) Key Frames
Click on the Adjust tab that is located on the top.
1. Select the layer you want to create the Key Frame.
2. Place the layer at the initial position and size.
3. Click the Blue "Add KF" button to create a new keyframe.
4. Move the layer at the end position and size.
Now the END state is saved only. The layer can move between the two states by clicking on the green arrows.
To execute the effect you now select the button ARM in the bottom of the workspace.
Keyframe will move the layer from the layers current position in Program to the Keyframed END position. This
allows re-using keyframe moves and other effects from ANY Preset as long as they are on the right layer.
Now you are ready to execute the presets and transition on the desired preview look into Program. Remember
to select the corresponding destinations when you use the Trans All button.
250 R5905948 EVENT MASTER DEVICES 17/07/2017