Barco S3 User Manual page 469

- Rear cards (VPU, Link, I/O)
- CPU module.
- Link card interposer.
Note: Refer to the related procedures to remove these parts. Remove these parts requires removing lot of parts from the unit
(Power supply, Power interposer, Power supply guide, Side Support Plate ...)
Note: It is not necessary to remove the solid state memory, the system battery and the other cables to give access to the
motherboard fixing screws.
6. Remove the Motherboard from the Motherboard mount.
a) Remove the three m/f standoffs (4-40 X 3/16" .25" ) that attach the Motherboard to the Motherboard mount.
b) Remove the five m/f standoffs (m2.5 X 8mm) that attach the Motherboard to the Motherboard mount.
c) Remove the sixteen long pan head SEMS screws (4-40x.31" — SEMS refers to an integrate lock washer) that attach the
Motherboard to the Motherboard mount.
Image 14-80
7. Locate the VFD cable that is plugged on the Motherboard.
R5905948 EVENT MASTER DEVICES 17/07/2017
14. S3 Maintenance
465