Barco S3 User Manual page 113

How to Auto create All Inputs
The "Auto Create Inputs" button automatically allocates all unassigned input connectors to an input. At this moment the incoming
signal is acquired and a sourcefile is saved. Input connectors that are already assigned to an input will not be affected. If the button
is pressed, 28 input configurations will be automatically assigned. Input1 contains the input connector on the 1st input card in slot
1, etc. The software by default names inputs as "Input 1, 2, 3....". Input configuration names can be renamed by double-clicking on
the name and turning the box blue.
How to Auto create all live Inputs
The "Auto Create live Inputs" button automatically allocates all live input connectors to an input. Input connectors that are already
assigned to an input will not be affected. If the button is pressed in the beginning, before any sources has been connected, no inputs
will be automatically assigned. Input1 contains the input connector on the 1st input card in slot 1, etc. The software by default names
inputs as "Input 1, 2, 3....". Input configuration names can be renamed by double-clicking on the name and turning the box blue.
Image 6-17
The auto create feature only creates up to 2K resolution inputs. Any special input like S3D and 4K Inputs need to be assigned
manually. See How to add Input section below.
How to add Input
Inputs configurations can be added manually to un-assigned connectors.
1. Click on the Add Input button.
The Add Input button is replaced by the Done Adding button (highlighted in blue).
R5905948 EVENT MASTER DEVICES 17/07/2017
This menu provides:
• A list of all the inputs already created on the system
(e.g. Cam 1, Input2).
• A button to automatically allocate all unassigned input
connectors to an input.
• A button to automatically allocate all LIVE input
connectors (GREEN) to an input.
• A button to manually allocate connectors to an input.
• A button to delete unused or obsolete inputs.
6. EM GUI orientation
109