Control Software Operation - Barco S3 User Manual

9.3

Control Software Operation

Overview
In this section we will use the control software (Event Master Toolset Software) to setup the E2 and create presets and user keys to
be used during the event. We will follow the steps sequentially outlined in diagram bellow.
Workflow Diagram
This diagram shows all the steps necessary to setup the system.
Image 9-4
Set up from A to Z
As outlined in the previous chapter the control software is divided in 3 parts:
1. Configuration Menu. In this section users define the system components like inputs, backgrounds, outputs and destinations.
See the detailed procedure in section"Configuration Menu", page 266.
2. Programming Menu. In this page users create sources from inputs, drop layers and backgrounds into screens and create User
keys and presets. See the detailed procedure in section "Programming Menu", page 271.
3. Multiviewer (MVR) Menu is the module used to setup the Multiviewer outputs (on one or two monitors). See the detailed proce-
dure in section "Multiviewer (MVR) Menu", page 282.
R5905948 EVENT MASTER DEVICES 17/07/2017
9. General operation example
265