Configuration Menu > Adjustment Area - Barco S3 User Manual

6. EM GUI orientation
6.11 Configuration Menu > Adjustment area
General
Situated on the right hand side of the screen is the Adjustment area. In this area the user can define and adjust unit specific param-
eters, inputs, backgrounds, outputs, multiviewer outputs and destination affected to the selected system.
Description
The following sections describe how to perform the configuration of each part of the system in detail:
• "Configuration Menu > Adjustment > Unit Configuration", page 105
• "Configuration Menu > Adjustment > Input Configuration", page 107
• "Configuration Menu > Adjustment > Background Configuration", page 116
• "Configuration Menu > Adjustment > Output Configuration", page 118
• "Configuration Menu > Adjustment > Destination Configuration", page 126
104
There are 4 tabs in this area:
• Input: this tab provides a list of all the created inputs. Here
the user can create new entries by associating them with
input connectors. It is also in this tab that the user can
delete unused or obsolete inputs.
• Background: provides a list of backgrounds of the selected
system. Similarly to inputs, the user can add and remove
Backgrounds from the system.
• Output/MVR: the user can add or remove program,
auxiliary and multiviewer outputs in this list.
• Destination: a destination is a location where the user can
route the output of Event Master series processor (screens,
widescreens, monitors etc.). The user could assign the
outputs that are created in the previous tab to destinations,
and deleted unused or obsolete destinations
Always on top:
• Adjustment: in this tab the user performs adjustments
available for the selected item (device, input, background,
output, destination). The content of this tab varies
depending on the selected item. Access to this area is
achieved from the System diagram area (click on device
or on a destination) or in one of the tabs of the Adjustment
area (input, background, output, destination) .
R5905948 EVENT MASTER DEVICES 17/07/2017