Barco S3 User Manual page 44

3. General
b) Measure the distance between the front and rear rack rails. Remove the mounting screws that secure each side rail to the
chassis, and then adjust the spacing of each side rail as necessary. The S3 uses four mounting screws on each side rail; the
EX uses two mounting screws on each side rail.
Image 3-15
S3–4K series side rail and mounting screws
1 Chassis rear
2 Side rail
3 Mounting screws
c) Re-install the mounting screws. When properly adjusted, the end of each side rail will protrude through the slot in the rear
mounting bracket, once the chassis is rack mounted.
2. Lift the chassis, and while supporting it, slide the side rails through the slots in the rear mounting brackets.
3. While continuing to support the chassis, install and tighten the two lower screws.
4. Finally, install and tighten the two uppers screws in the rack rail.
40
Image 3-16
EX expansion box side rail and mounting screws
1 Chassis rear
2 Side rail
3 Mounting screws
R5905948 EVENT MASTER DEVICES 17/07/2017