Installing The Ne Controller - Canon iR4570 Series Service Manual

2.7 Installing the NE Controller

2.7.1 Installing the NE Controller-A1
iR2270 / iR2870 / iR3570 / iR4570
When installing the NE Controller-A1 to its host machine, take note of the following:
1. be sure to perform the work in compliance with the laws and regulations of the country in question.
2. be sure that the host machine has properly been installed before starting the work.
3. be sure to disconnect the power plug of the host machine before starting the work.
4. be sure to identify the screws by type (length, diameter) and location.
5. be sure the settings data are ready on the PC at the service station.
1) Remove the 2 screws [2] of the top cover [1], and detach the cover.
2) Connect the connector [1] of the power supply unit to the connector [2] as shown.
3) Remove the 4 screws [1], and detach the face plate [2] of the host machine's rear cover.
[1]
[2]
F-2-76
[2]
[1]
F-2-77
[2]
Chapter 2
0007-5625
2-33