Removing The Right Cover (Rear) - Canon iR4570 Series Service Manual

Chapter 10
F-10-173
2) Disconnect the 3 connectors [1] found at the front
and the connector [2] found at the rear.
F-10-174
3) Open the 11 wire saddles [1], and pull out the
harness [3] through the hole [2] in the plate.
F-10-175
4) Remove the 3 screws [1], and detach the hopper
assembly [2].
10-54
F-10-176
When fitting the hopper assembly to the machine, be
sure that the connectors [1] are securely connected. If
the connectors [1] are not connected, the environment
heater will not be supplied with power, leading to
image faults.
F-10-177
10.5.12.12 Removing the Right
Cover (rear)
iR2270 / iR2870 / iR3570 / iR4570 / iR3530
1) Open the pedestal right door [1]. (if equipped with
a 2-Cassette Pedestal-Y2)
2) Open the right lower door [2].
3) Remove the 5 screws [3], and detach the right cover
(rear) [4].
0007-8412