Canon iR4570 Series Service Manual page 130

Chapter 2
not, be sure to make the following adjustments
1) Make the following in service mode: COPIER
>ADJUST >FEED-ADJ >REGIST.
2) Change the setting to make adjustments. (A change
of '1' made to the setting will cause a move of 0.1
mm. A lower setting will move the image toward
the leading edge.)
L1
F-2-56
2.2.10 Attaching
Parts
iR2270 / iR2870 / iR3570 / iR4570
- Service Book Holder
1) Remove release paper of the double-sided tape on
the rib of the service book folder [1], and attach the
holder to the bottom plate of the pedestal.
F-2-57
Locations where the service book folder cannot be
2-20
Other
0007-5087
attached.
- Inside the machine (Inner side of the front cover)
- Locations where the louver is blocked.
- Locations where the grips are blocked.
Memo:
Attach the service book holder to the left cover of the
machine if the pedestal is not installed.
- Lower right cover
1) Attach the lower right cover [1]. (Perform this step
when attaching the machine to the 2-level cassette
pedestal Y2 or more.)
F-2-58
- Shut-Down Warning Label
1) Attach the Shut-Down warning label [1] of the
appropriate language to the right cover (rear) of the
machine (i.e.,. on the left inside [2] of the main
power supply.).
[2]
F-2-59
[1]