Adjustment And Cleaning - Canon iR4570 Series Service Manual

Mode
center bind position
change** (w/ saddle finisher)
density correction
page print/number of set
prints adjust stamp position
clean feeder***

1.2.3.6 Adjustment and Cleaning

/ iR3530
*Factory default.
***Indicated when appropriate accessories are installed.
Mode
zoom fine-adjust
density correction
feeder cleaning***
1.2.3.7 Report Output
iR2270 / iR2870 / iR3570 / iR4570
*Factory settings.
***If iR4570, iR3570, iR2870, or iR2270, indicated in the presence of a specific accessory (if model F, standard).
Mode
transmit (setup)***
Description
size: A3,11x17/B4/LGL/A4R,LTRR
position: -2.0 mm to +2.0 mm (in 0.35-mm increments)/*0 mm
copy/Box, transmit; 9 sets each (at time of shipment, set to '5')
X: -8 mm to +8 mm (in 1-mm increments)/*0 mm
Y: -8 mm to +8 mm (in 1-mm increment)/*0 mm
Start key
T-1-32
Description
XY independent: -1.0% to +1.0% (in 0.1% increments), *0%
copier/box, transmit (each in 9 steps; at time of shipment, set to '5')
Start key
T-1-33
Description
transmission results report: *only if error/ON/OFF
show transmission original: *ON/OFF
show transmission original for coded PDF: ON/*OFF
communication control report
print automatically at 100 communications:
print at specified time: ON/*OFF
set time: *00:00 to 23:59
separate transmission and reception: ON/*OFF (toggle)
Chapter 1
0009-2479
0007-3167
1-45