Canon iR4570 Series Service Manual page 887

Sub-item
FX-FL-SP
FX-FL-TH
FX-FL-
LW
<MISC>
Sub-item
IMG-
DLY
COPIER > ADJUST > FIXING
Description
Entering a fine adjustment value for the fixing film speed when plain
paper is used.
Make a fine adjustment of the target control speed for the fixing film
speed when plain paper is used.
<Setting range> -3 to 3 (Default: 0) (Unit: ms)
If RAM on the DC controller circuit board has been cleared or the
board itself has been replaced, enter the value from the service label.
Entering a fine adjustment value for the fixing film speed when thick
paper is used.
Make a fine adjustment of the target control speed for the fixing film
speed when thick paper is used.
<Setting range> -3 to 3 (Default: 0) (Unit: ms)
If RAM on the DC controller circuit board has been cleared or the
board itself has been replaced, enter the value from the service label.
Entering a fine adjustment value for the fixing film speed when low-
speed plain paper is used.
Make a fine adjustment of the target control speed for the fixing film
speed when low-speed plain paper is used.
<Setting range> -3 to 3 (Default: 0) (Unit: ms)
If RAM on the DC controller circuit board has been cleared or the
board itself has been replaced, enter the value from the service label.
COPIER > ADJUST > MISC
Description
Entering a fine adjustment value for the image delay in the subscan
direction
Make a fine adjustment of the image delay in the subscan direction when
image data is transferred from the controller board to the DCON board.
<Setting range> -128 to 127
iR2270/2270F/2870/2870F: +23 (Default)
iR3570/3570F/4570/4570F: +35 (Default)
If RAM on the DC controller circuit board has been cleared or the board
itself has been replaced, enter the value from the service label.
T-16-27
T-16-28
Chapter 16
Level
2
2
2
Level
1
16-43