Canon iR4570 Series Service Manual page 696

Chapter 13
If the user uses NetSpot Accountant (NSA) in
Combination with a Card Reader
The SDRAM of the main controller retains card ID
used by NSA. If you have replaced the main
controller, you will have to download the card data
from NSA once again to permit NSA to perform
statistical operations.
If you have formatted the HDD and downloaded the
system software, you will have to go through a
specific set of steps:
1) Format the HDD.
2) Download the system software.
3) Make the following selections:
COPIER>FUNCTION>INSTALL>CARD.
4) Enter a card No.
Enter the first of the numbers that will be used for
group control, and press the OK key (e.g., if you are
planning to use cards from No. 1 thorough No. 100,
enter '1').
5) turn off and then on the main power.
6) Check the count control mechanism in user mode.
system control setup>group ID control>count
control
check to see as many as 'ID00000001 through
ID00001000' have been prepared.
7) Set the IP address in user mode.
control setup>network
system
setup>IP address
Set 'IP address', 'gateway address', and 'sub net mask'.
8) Enter a number of your choice in user mode.
system administrator info setup>system control
group ID>system control ID No.
9) Hold down the control panel power switch for 3 sec
or more.
10) Go through the instructions on the control panel
for shut-down sequence so that the main power switch
may be turned off.
11) Turn off the main power switch. Wait for 3 sec or
more, and turn it back on.
Unless you have registered 'system control group
ID' and 'system control ID No.', you will not be able to
13-12
register cards for the device in the course of Net Spot
Accountant setup work.
12) Download the card ID.
Keep the machine in a standby state < and
download the card ID to be used from the NSA>
13) Check the count control particulars in user mode.
system control setup>group ID control>count
control
14) Check to see that the operation is normal.
registered using the NSA, and check to see that the
count of the card in question has been incremented
correctly.
13.5.4 After Replacing the
iR2270 / iR2870 / iR3570 / iR4570 / iR3530
sure to print out the latest P-PRINT page.
reader controller without replacing the PCB>
controller, and download it after initializing the RAM
so that you need not perform the following:
setup>TCP/IP
1. Reader Unit-Related Adjustments
1) Using the SST, download the latest system
software (R-CON).
2) Make the following selections in service mode:
COPIER>FUNCTION>LEARN>R-CON.
press the OK key to initialize the RAM; thereafter,
turn off and then on the main power.
3) Enter the following values in service mode:
a. values indicated on the service label (found
behind the left cover of the reader unit)
COPIER>ADJUST>ADJ-XY>ADJ-X
See that only the downloaded ID data is shown.
Make copies using a user card that has been
Reader Controller PCB
- Before replacing the reader controller PCB, be
<if you are executing RAM initialization for the
- Using the SST, upload the backup data of the reader
a-1. CIS read position adjustment (for fixed reading)
a-2. main scanning direction position adjustment
0007-9843
Then,