Microphone/Speaker Sensitivity Adjustment (Speakerphones Only); Busy Override And Camp-On Ring Tone Over Handset/Headset Option - Toshiba Strata DK40 Installation & Maintenance Manual

Telephone Upgrades
Microphone/Speaker Sensitivity Adjustment
(Speakerphones Only)
High ambient noise levels may cause the speaker on some digital telephone speakerphone
models to cut off frequently.
To make the 2000-series digital telephone models less sensitive to loud surrounding noise
To reset the sensitivity back to the normal level
Note
Busy Override and Camp-on Ring Tone Over Handset/
Headset Option
Using a 2000-series digital telephone, the busy override and camp-on ring tones can be sent
over the telephone handset or headset, in addition to the speaker.
To send busy override/camp-on ring tones over the handset of the DKT2010-FH model
1. Loosen the four captive screws securing the telephone base
base.
2. Install a strap in the HS-BOV W409 location
3. Reinstall the telephone base, and secure it with its four captive screws.
To send busy override/camp-on ring tones over the handset/headset of the DKT2010-FS/
DKT2010-FSD/2020-FS/2020-FSD
To block the tone over the handset/headset of the DKT2010-FS/DKT2010-FSD/2020-FS/
2020-FSD
Note
Strata DK40 I&M Manual Spring 1999
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
Hold down 0LF button, then press the 9RO
be set after the third flash of the Mic LED.
Hold down the 0LF button, then press the 9RO
set after the third flash of the Mic LED.
On 2000-series digital telephone speakerphone models that are set for low
sensitivity, the Mic LED will flash at the in-use rate when using the speakerphone.
When set to normal sensitivity, the Mic LED is on steady when using the
speakerphone.
Hold down the 5HGLDO button and press the 9RO
Hold down the 5HGLDO button and press the 9RO
For this to function properly with headsets, make sure the speaker OCA strap or
R607 is cut on the HHEU PCB and the HHEU strap is cut on the telephone.
"Loud Ringing Bell/T001B Headset Upgrade (HHEU)" on Page 5-11 for more
information.)
button. The less-sensitive level will
button. The normal level will be
(Figure 5-1), and remove the
(see Figure 5-6).
button.
button.
Station Apparatus
(See
5-15