GE Reason H49
12.2
Appendix 2 Command Line Use Cases
Note:
All variable parameters and values used in this section are chosen arbitrary and only for description purposes.
12.2.1
System Commands
12.2.1.1
Redundancy
Command
redundany -l -n -a
redundancy –l HSR-PRP-A –n 2 –a 01:15:4E:00:01:00
12.2.1.2
System
Command
system -a -n -g -c -t
system –a 192.168.254.254 –n 16 –g 0.0.0.0 –c SWH49 –t ptp
H49/EN M/C22
This section figures out the usage of the H49 command lines with simple examples.
The example below shows the use of the
Sets the Reason H49 redundancy mode, the network ID and the
redundancy supervision MAC address
Example:
The example below shows the use of the
Sets the switch IP address, netmask, name and synchronization type
together with the gateway IP address
Example:
Technical Manual
redundany command line:
Description
system command line:
Description
149